SMR Gearbox Installation
Satisfactory overall performance is dependent upon proper set up. lubrication and maintenance. for that reason it is important that the directions from the set up and maintenance leaflet. supplied with each gearbox. are followed carefully. some of the vital facets of belt and torque-arm set up are listed beneath.
one. Install pulley on gearbox input shaft as shut to the reducer possible, and mount reducer on driven shaft as close to bearing as useful. failure to accomplish this will lead to excess loads within the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive with the belt pull at approximately 90° towards the center line among driven and input shafts. this will permit tensioning of your wedge belt drive with all the torque arm which ought to ideally be in stress. if output hub runs anti-clockwise. torque arm should be positioned the appropriate.
3. lnstall torque-arm fulcrum on the rigid help to ensure that the torque-arm will probably be 
at approximately right angles towards the center line through the driven shaft plus the torque arm case bolt. be sure there exists enough get up during the turnbuckle for belt tension adjustment.
Hold shut.
Bell drive may very well be located in any effortless postion. in case the torque arm will be to be utilized to tighten the belts, the drive must be at about tight angle to your line involving the input and output shafts.
Bell drive could possibly be located for the proper if preferred.
If output hub rotates clock-wise. position belt drive and torque arm in opposite direction to that shown within the illustration.
Torque arm and belt get up.
Torque arm may be mounted to the correct if preferred.
